• Eucatex Copal Varnish

The colors and patterns on this site are only for reference, there may be divergence between the colors on the screen and the real colors of products. Availability on request.

With quick drying, it has a fine, natural, gloss finish

Eucatex Copal Varnish is a product with a fine, natural, gloss finish easy to apply and with a high penetration power, quick drying, high yield and great adherence to the substratum. It is indicate for internal wood surfaces, as entrances, doors, banisters, counters, furniture, ceilings etc.


Alkyd resin, solvents of the aliphatic and aromatic hydrocarbon type, organometallic dryers and additives. It does not contain benzene and heavy metals.
This product is classified according to  standard NBR 11.702 of the ABNT (Brazilian Technical Standards Association) Type

  with Turpentine m2/coat  

First coat:
20% to 25%
Others: 15%

8 to 12
35 to 45

¼ of Gallon (900 ml)
Gallon (3.6 liters)


Two to three coats with an
interval of 12 hours

Drying Period: To touch: 4 to 6 hours
Final: 24 hours

Foam roller


*Spray gun

*For the Spray gun, use  pressure between  2.2 and 2.8 kgf/cm² or 30 to 35 lbs/in.²)
  • For a perfect finishing, in new woods of non-wettable areas, use Eucatex Sealer for Wood  as a primer;
  • Removers in the wood can cause problems of drying and finishing in the coatings applied after the removal. If you use removers, clean the wood effectively to minimize the  occurrence of these problems;
  • The practical yield can vary due to the method of application, geometry of the structure, rugosity and absorption of the surface, thickness of the product layer deposited, atmospheric conditions and application technique;
  • When using the product on new woods, observe the dilution item carefully for the first coat, as the recommendations described are factors of paramount importance for the good performance of the product. Note: when applying with a foam roller, it is natural for microfoam to appear, which will disappear during the drying process;
  • In cases of resinous woods, bathe them successively with Eucatex Thinner until the complete decontamination of the wood.

According to ABNT NBR 13.245.

  • Preparation: the surface must be firm, cohesive, clean, dry, without dust, fatty materials, and mould.
  • Surfaces which have a gloss: they should be sanded until they are completely matt before starting to apply the varnish.
  • Surfaces with fatty stains: they should be washed with a solution of water and neutral detergent. Then, rinse them well, wait for them to dry and apply the product.
  • New woods not dry: they must receive successive applications of Thinner until the complete elimination of the natural resin of the wood, which can damage the paint.
  • New dry woods: sand the surface to eliminate splinters and remove the residue. In non-wettable areas, apply a coat of Eucatex Sealer for Concentrated Wood, diluted 100% with Eucatex Thinner. After the drying, sand again and eliminate the dust.
  • Repainting: remove loose flakes, sand to remove the gloss and make a new application.